Bowflex Blaze Assembly Manual - Page 16
Step 14 - Attach the Leg Extension Seat to the Main, Assembly, Step 15 - Attach the Lat Cross Bar
View all Bowflex Blaze manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Assembly Guide Step 14 - Attach the Leg Extension Seat to the Main Assembly Locate the following items: • From Step 13 - Leg Extension Seat Assembly • From Step 12 - Main Assembly The Leg Extension Seat Assembly is removable, and can be attached to the Rear Leg Assembly easily by placing the Rail Bracket Hooks over the Rear Rollers. Place the Rail Bracket Hooks onto the Roller Tube Spacers (sandwiched between the Rear Leg and the Foam Rollers). Once the Support Tube Bracket Hooks connect with the Roller Tube Spacers, slightly "roll" the back edge of the Seat down to lock into place. Warning: For your safety, always ensure that the Support Tube Bracket Hooks fully engage with the Roller Tube Spacers. To remove the Leg Extension Seat Assembly, reverse this procedure. Figure 14 Leg Extension Seat Support Tube Bracket Hooks Roller Tube Spacers Back Edge Step 15 - Attach the Lat Cross Bar to the Upper Lat Tower Locate the following items: • Item #22 - Lat Cross Bar - Do not unwrap cables! • Item #23 - Upper Lat Tower • Item #H - (2) 3/8" X 3" Button Head Screws • Item #N - (4) 3/8" Washers • Item #O - (2) 3/8" Nylock Nuts Align the holes in the Lat Cross Bar (Item #22) with the holes in the bracket on the Upper Lat Tower (Item #23). Place (2) 3/8" Washers (Item #N) over the ends of (2) 3/8" X 3" Button Head Screws (Item #H) - one washer per screw. Thread the screws through the aligned holes, then secure by placing (1) 3/8" Washer and (1) 3/8" Nylock Nut (Item #O) over each screw and tighten. Completely tighten hardware installed during Step 15. Figure 15 O N H 23 22 Lat Tower Bracket 14