Brother International BAS-300A Application Instruction Manual - English - Page 17
Brother International BAS-300A Manual
View all Brother International BAS-300A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
B. To program a symmetrical pattern design, the operator is only required to program one-half of the pattern and use of the numeral keys to program the remaining half of the design. Example: Program, on the Y axis, a symmetrical mirror of the pattern in the figures below. (1) Press the D key. The work clamp will move to the point of origin (X-0; Y-0), the numeral "0" will be indicated on the display, and the command indicator "F" will illuminate. (2) Operate the direction keys to move the work clamp to the initial stitch position. (3) When the tip of the needle and the initial stitch position ® on the outline of the needle movement become aligned, press the 0 key. Thus, the initial stitch will be programmed. (4) Repeat the above procedure to program the left-side half of the stitch pattern from point ® to point 0 ®. (5) Press the E key at point Then, operate the numeral keys to indicate "442" on the STEP display, and press the E key once again. (6) The tip of the needle will slowly move from point ® to point QS), and the right side half of the pattern design will be automatically programmed. At this time, if the presser-lifter pedal is pressed, the work clamp will be fast-forwarded. (7) When the tip of the needle becomes aligned with point ®, press the numeral key u1 3 times to indicate "111" on the STEP display. Then, press the E key. (8) The work clamp will move back to the initial stitch position. (9) Press the program RAN switch to write the pattern to disk. (Refer to page 24.) )K Repeat Y-axis (442), origin point (440), and X-axis (441) to program pattern (443). (X-0 Y-0) 3 El • "442" • E "440" LI "441" ."443" -14-