Brother International BAS-300A Application Instruction Manual - English - Page 9
program, stitch, pattern, containing, numerous, straight, lines, design
View all Brother International BAS-300A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
El To program a stitch pattern containing numerous straight lines in the pattern design • To program the straight-line portions of the pattern design, use the a key (Line key) to facilitate the programming operation. Example: Program the pattern in the figure below. • (1) Press the key. The work clamp will move to the point of origin (X-0; Y-0), the numeral "0" will be indicated on the STEP display, and the command indicator "F" will illuminate. (2) Operate the direction keys to move the work clamp to the initial stitch position. (3) When the tip of the needle and the initial stitch position ® on the outline of the needle movement become aligned, press the ID key. Thus, the initial stitch will be programmed. (4) Operate the numeral keys to indicate the proper pitch on the STEP display. (For example, to set the proper stitch length when the actual stitch length is 3 mm, use the numeral keys to indicate "030" on the STEP display.) )K If the pitch is not indicated on the STEP display, or if it is less than 0.2 mm or greater than 12.7 mm ("127" on the STEP display), it (x-o • Y-0) will automatically be set to 2 mm. (5) Press the LI key. The command indicator "LI" will illuminate. amis. CD• "030" •E] (6) Use the direction keys to move the work clamp to the final stitch position 411 on the straight line portion of the pattern design. Note 1 When more than 120 stitches are required between point ® and point O), the operation speed of the work clamp will suddenly decrease to warm the operator. Therefore, press the key and then the El key between point ® and point 43 to reprogram the remaining stitches on the straight-line portion of the pattern design. (7) Press the O key when the tip of the needle becomes aligned with point ® on the outline of the needle movement. Thus, the straight-line portion from point ® to point ® will be programmed. (8) Repeat the above procedure to program the remaining straight-line portions from point 0-4 ©, (0-x1), o-e. Note 2 For diagonal lines, e.g. g)-.)(), CD-4e, there are instances in which the line may not turn out to be straight unless the line is subdivided into smaller portions. e. (9) Press the (D key at the position indicated by the letter Then, press the numeral key M 3 times to indicate "111" on the STEP display, and then press the 0 key. (10) The work clamp will move back to the initial stitch position. (11) Press the program R/W switch to write the pattern to disk. (Refer to page 24.) -s