Brother International Entrepreneur Pro PR1000e Users Manual - English - Page 117

If the Thread Breaks or the Bobbin Thread Runs Out While Embroidering If the thread breaks or the bobbin thread runs out while embroidering, the machine will automatically stop. Since some stitches may be sewn with only one thread, go back through the stitching to a point where stitches have already been sewn before continuing embroidering. Note Touch to check the needle drop 3 point on the LCD screen. ● If the thread sensor is turned off, the machine does not stop until embroidering is finished. Normally, the thread sensor should be turned on. (Refer to page 230.) ● Be careful when going back or forward through the stitching since the embroidery frame moves at the same time. 3 Memo ● When the thread breaks or the bobbin thread runs out while embroidering, the spool stand LEDs flash to notify you of the problem. X The camera view window appears. • Touch to zoom up the camera view twice the size of normal view. If the upper thread breaks Re-thread the upper thread. (Refer to 1 page 56.) Touch . 2 Touch and to go back 4 through the stitching to a point where stitches have already been sewn. 1 2 X The stitch navigating screen appears. 1 Each touch of this key moves one stitch back through the stitching. 2 Each touch of this key moves ten stitches back through the stitching. If the Thread Breaks or the Bobbin Thread Runs Out While Embroidering 115