Brother International Entrepreneur Pro PR1000e Users Manual - English - Page 276

APPENDIX Installing the embroidery frame holder After embroidering using the cap embroidery frame is finished, remove the needle plate spacer and cap frame driver, and then re-attach the embroidery frame holder. Remove the needle plate spacer. 1 Remove the cap frame driver. 4 1 Needle plate spacer Loosen the two lower thumb screws. 2 Note ● Be careful that the cap frame driver does not hit any nearby parts, such as the presser foot. With the hole on the sweat guard holder 5 aligned with the centerline of the guiding plate, insert the two thumb screws removed in step 3 into the holes at the top, and then tighten the thumb screws. 1 Thumb screws Remove the two upper thumb screws 3 1 Hole on the sweat guard holder 2 Centerline of guiding plate 3 Holes on the top • Insert the thumb screws into the holes where the cap frame driver that was originally installed (holes that the thumb screws were removed from in step 2 on page 261). X The movable section of the cap frame driver is secured. 1 Thumb screws 274