Brother International Entrepreneur Pro PR1000e Users Manual - English - Page 33

Grab the grips on the thread guide assembly 2 support and push toward the middle. Preparing the spool stand Secure the spool stand in place for embroidering. Use the included disc-shaped screwdriver. 1 Loosen the thumb screw two or three turns, 1 and then fold out the spool stand. After the thread guide assembly support is 3 extended and the thread guide assembly is raised to its highest position, tighten the two thumb screws to secure the thread guide assembly in place. 1 Thumb screw 2 Spool stand After the spool stand is fully opened up, 2 tighten the thumb screw. X Secure the spool stand in the opened position. 1 Tighten screw. 2 Thread guide assembly support 3 Thread guide assembly Note ● If the thumb screws are not loosened enough, it may not be easy to move the thread guide assembly support. Do not apply extreme force when moving the thread guide assembly support. Be sure that the thumb screws are loosened well enough before moving the part. ● Be sure to tighten each thumb screw well enough that the thread guide assembly support is secured. Setting Up the Machine 31