Brother International HL 1030 Service Manual - Page 29
For Windows, Users with No CD-ROM Drive, Paper should be loaded up to - driver windows 8
UPC - 012502020134
View all Brother International HL 1030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
CHAPTER 2 INSTALLATION AND BASIC OPERATION 3.2 For Windows® Users with No CD-ROM Drive If you do not have a CD-ROM drive, setup the printer following the steps below, then install the printer driver from the floppy disk. 3.2.1 Install the drum unit (1) Open the front cover. (2) Unpack the drum unit assembly and rock it from side to side 5 or 6 times to distribute the toner evenly inside the cartridge. (Fig. 2-8) Fig. 2-8 (3) Install the drum unit into the printer until it snaps into place and close the front cover. 3.2.2 Load paper (1) Pull the paper cassette completely out of the printer. (2) Slide the paper guides to the paper size you want until they snap into a slot. (Fig. 2-9) (3) Load paper into the paper cassette. Check that paper is flat placed. (Fig. 210) Paper should be loaded up to the lines on the sliding guide. (4) Re-install the paper cassette into the printer. Fig. 2-9 3.2.3 Print a test page (1) Check that the power switch is off. (2) Connect the AC power cord to the printer. (3) Plug the AC power cord into an AC outlet, then turn on the power switch. (Fig. 2-11) Fig. 2-10 Fig. 2-11 AC power cord 2-5