Brother International HL-1660E Service Manual - Page 398

OPERATION MANUAL Settings on the Control Panel You can make some settings for the fax functions on the printer control panel as in the following steps; 1. Press the SEL switch to make the printer off-line. 2. Press the MODE switch to enter the Mode Menu. Then, 'INTERFACE MODE' is displayed first. 3. Press the v or w switch until 'ADVANCED MODE' is displayed. 4. Press the SET switch. 5. Press the v or w switch until 'FAX MODE' is displayed. 6. Press the SET switch. ✒ Note: 'FAX MODE' is not displayed when 'FAX MODEM=OFF' is selected in the 'HIDDEN PANEL' menu. Refer to the previous section, 'Installing the External Fax Modem'. You can now make the following settings; Menu RING DELAY REDUCTION FAX RAM SIZE RECEIVE INTERVAL Descriptions Number of rings before the printer answers when receiving fax data. Select from 0 to 4. The factory default setting is 2. Set if the received fax data is reduced for printing or not. AUTO: reduced automatically (factory default setting) OFF: not reduced automatically 90%: reduced to 90% Set the RAM size used for the fax function. After turning the printer off and on the setting is active. The factory setting is 1MB. The maximum size that can be set is 15 MB, this depends on the memory size installed into the printer. Select if the printer is to receive fax data or not. When the printer only sends Fax data, select this to OFF. ON: Receive fax data (factory default setting) OFF: Does not receive fax data Set the interval to print a fax sent / received report. The factory setting is OFF. Select one of the following 7 types. OFF: No printing 6H: every 6 hours 12H: every 12 hours 24H: every 24 hours 2D: every 2 days 4D: every 4 days 7D: every 7 days -6-