Brother International HL-1660E Service Manual - Page 55
Control Panel Unit
View all Brother International HL-1660E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
1.9 Control Panel Unit Screws Pin Switch flat cable 21P Panel arm L Control panel unit Main PCB Figure 4.15 (1) Remove the left side the control panel from the arm L by loosening the screws of the panel arm L. (2) Remove the switch flat cable 21P from the main PCB. (3) Remove the control panel from the right panel arm R pin by sliding the control panel to the right. C D A B A Tilt the control panel unit. B Pinch the lever. C While pinching the lever, rotate, downward toward you, the control panel unit on the right pin taken as a fulcrum. D Remove the control panel unit. Figure 4.16 (4) Release the panel sheet 8 hooks to remove the panel sheet from the control panel. Control panel unit 8 Hooks COPY PAGES ORIENTATION DUPLEX FEEDER READY DATA ALARM ON LINE SEL FONT FORM FEED MODE EMULATION ECONOMY FEEDER SET COPY CONTINUE SHIFT RESET TEST Panel sheet Figure 4.17 IV - 8