Brother International HL-1660E Service Manual - Page 69

1.30 Transfer Unit (1) Loosen a screw. (2) Release the 3 right hooks, (see Figure 4.57) lift the right part of the unit ( A ) and slide it to the right ( B ) to take off the left part from the main chassis L. Remove the transfer unit from the body by lifting the former. Screw Transfer unit Main chassis L Right Figure 4.56 (3) Open the transfer base hook and take off the left bearing (white) from the hook ( A ). Lift the left side ( B ), slide it to the left ( C ) and take off the roller shaft from the right bearing (black) ( D ). (4) Remove the transfer roller assy. Caution : Do not touch the sponge rubber roller when replacing the transfer roller (the roller with hand grease or clasped too strongly may result in poor printing quality). A AB 3 Hooks Transfer base assy D C Transfer roller assy Figure 4.57 IV - 22