Brother International Innov-is VM6200D Operation Manual - Page 320
Error Messages
View all Brother International Innov-is VM6200D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 320 highlights
ERROR MESSAGES ERROR MESSAGES If the machine is not properly set and the "Start/Stop" button or the "Reverse Stitch" button is pressed, or if the operation procedure is incorrect, the machine does not start. An alarm sounds and an error message is displayed on the LCD. If an error message displays, follow the instructions in the message. Below is an explanation of error messages. Refer to these when necessary (if you press operation correctly while the error message is displayed, the message disappears). or do the CAUTION • Be sure to rethread the machine. If you press the "Start/Stop" button without rethreading the machine, the thread tension may be wrong or the needle may break and cause injury. Marks Error Messages A malfunction occurred.Turn the machine off, then on again. Cause/Solution This message is displayed if some malfunction occurs. An invalid area was touched by the sensor pen. Touch again This message appears when you touch the invalid area of within the active sensor area. (130mm x 200mm / 5"X 8") sensor pen. Touch the active area. (see page B-76) An invalid sewing area was touched by the sensor pen. Touch This message appears when you touch the invalid area of again within the valid sewing area. sewing with the sensor pen. Touch the active area. (see page B-76) Attach the embroidery frame. This message appears if the embroidery frame is not attached Can not change the configuration of the characters when you press in the embroidery screen. (see page B-83) This message is displayed when there are too many characters and the curved character configuration is impossible. Check and rethread the upper thread. Data volume is too large for this pattern. Failed to save file. In twin needle mode, the automatic needle threading button cannot be used. This message is displayed when the upper thread is broken or not threaded correctly, and the "Start/Stop" button or the "Reverse Stitch" button is pressed. This message is displayed when the patterns you are editing take up too much memory, or if you are editing too many patterns for the memory. This message appears when you try to save more than 100 settings screen image files in the USB media. In this case, delete a file from the USB media or use different USB media. (see page B-35) This message is displayed when the automatic needle threading button is pushed while twin needle sewing is set. Lower the buttonhole lever. This message is displayed when the buttonhole lever is up, a buttonhole stitch is selected, and the "Start/Stop" button or "Reverse Stitch" button is pushed. Lower the presser foot lever. This message is displayed when the "Presser Foot Lifter" button is pushed while the presser foot lever is raised/the needle is lowered. Move the sensor pen away from the currently marked position. This message appears when you press down the sensor pen Not enough available memory to save the pattern. Delete another pattern? tip before pressing and keep pressing for the certain period. Move the sensor pen away from the current position. This message is displayed when the memory is full and the stitch or pattern cannot be saved. OK to automatically lower the presser foot? OK to delete the ending point setting? This message is displayed when is pressed (the presser foot is raised). This message appears when you try to recall the pattern stored in the machine while specifying the sewing end point using the sensor function. (see page B-81) A-34