Brother International Innov-is VM6200D Operation Manual - Page 65

BEFORE EMBROIDERING ■ Adjusting the LED Pointer d Press . Adjust the LED pointer if it indicates a point different → The Embroidery Foot "W+" with LED Pointer than the actual needle drop point. Adjustment screen appears. B Before adjusting the LED pointer, mark the actual needle drop point on the fabric to be embroidered, and then hoop the fabric and attach the embroidery a 1 frame. Getting Ready Note • As a default, some keys mentioned in the following procedures appear in light gray and are not available. To enable the keys for specifying the settings, attach embroidery foot "W+" with LED pointer to the machine. The keys are enabled after the embroidery foot is detected. a Press . → The settings screen appears. b Press . → The Embroidery settings screen appears. Memo • When using the "Embroidery" or "Embroidery Edit", touch to directly access the Embroidery settings screen. c Display screen. page 10 of the Embroidery settings a LED pointer adjustment Note • The specified setting is saved in the machine's memory. This is useful for positioning during continuous embroidering. • For normal use, return the setting to "00". e Use that it or to adjust the LED pointer indicates the actual needle drop so point. f Press screen. twice to return to the original ■ Adjusting the Brightness of the LED Pointer a Follow the steps from a to d to display the embroidery foot with LED pointer adjust screen. b Use or to the LED pointer. adjust the brightness of c Press screen. twice to return to the original Basic operations B-63