Brother International Innov-is VM6200D Operation Manual - Page 322
Character/Decorative Stitch.
View all Brother International Innov-is VM6200D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 322 highlights
ERROR MESSAGES Marks Error Messages The pockets are full. Delete a pattern. Cause/Solution This message is displayed when the memory is full and a pattern must be deleted. The safety device has been activated.Is the thread tangled? Is This message is displayed when the motor locks due to the needle bent? tangled thread or for other reasons related to thread delivery. The shutoff support mode has been activated. Turn off the machine. The "Start/Stop" button does not operate with the foot controller attached. Remove the foot controller. The upper thread may not be threaded correctly. Thread the upper thread from the beginning. This message appears when the machine is in the shutoff support mode. Turn off the machine once to start the machine again. (see page B-32) This message is displayed when the "Start/Stop" button is pushed to sew Utility stitches or Character/Decorative stitches while the foot controller is connected. (This message does not appear when embroidering). This message is displayed when it seems that the upper thread has not been threaded correctly. The USB media was changed. Do not change the USB media This message is displayed when you attempt to select a while it is being read. pattern after the USB media in which the pattern is saved has been changed. There is no needle plate cover. Attach a needle plate cover. This message is displayed when the needle plate cover is not attached. This file cannot be used. This message appears if the file format is incompatible with this machine. Check the list of compatible file formats. (see page S-94) This file exceeds the data capacity and cannot be used. Use a This message is displayed when the file size exceeds the data suitable size file. capacity of the machine. Confirm the file size and format. (see page S-95) This function cannot be used while in the sensor mode. This message appears when the selected function is not available with the sensor function. (see page B-71) This key cannot be used at this time. This message is displayed when you press in the screen other than the Utility Stitch, or press in the screen other than the Utility Stitch or Character/Decorative Stitch. This key does not operate when the needle is down. Raise the This message is displayed when a key on the LCD display is needle and press the key again. touched while the needle is in the down position. This pattern cannot be sewn with this mode. This message is displayed when the selected stitch is not available for the specific function. This stitch is not "Dual Feed Mode" compatible. This message appears when the dual feed foot cannot be used with the current stitch. Select other stitch. (see page B-67) This USB media cannot be used. This message is displayed when you try to use incompatible media. This USB media is incompatible. Transmitting by USB This message is displayed when you try to use incompatible USB media. For a list of compatible USB media, visit " http://solutions.brother.com ". This message is displayed while the USB media is transmitting. Turn off the power and replace the needle plate. USB media error This message is displayed when you try to sew with a stitch other than a middle needle position stitch while the single-hole needle plate is installed. This message is displayed when the needle plate is removed with the machine on or when the machine is turned on and "Embroidery" or "Embroidery Edit" mode is selected (see page B-24). This message is displayed when an error occurs with the USB media. USB media is not loaded. Load USB media. This message is displayed when you try to recall or save a pattern while no USB media is loaded. Use the presser foot lifter button to lower the presser foot. This message is displayed when a button, such as the "Start/Stop" button, is pushed while the presser foot is raised. A-36