Brother International Innov-is VM6200D Operation Manual - Page 64

BEFORE EMBROIDERING g Hold the embroidery foot your right hand, and then in place with use the included screwdriver to securely tighten the presser foot holder screw. ■ Checking the Needle Drop Point With the Embroidery Foot "W+" with LED Pointer Before beginning to embroider when using the embroidery foot "W+" with LED pointer, carefully read the procedures described in the "Embroidery" and "Embroidery Edit" chapters. a After the embroidery frame is attached, press in the embroidery screen. → The LED pointer indicates the needle drop point. CAUTION • Use the included screwdriver to firmly tighten the screw of the embroidery foot. If the screw is loose, the needle may strike the presser foot and possibly cause injury. h Plug the connector of the embroidery foot "W+" with LED pointer into the jack on the back of your machine. i Press buttons. to unlock all keys and → All keys and operation buttons are unlocked, and the previous screen is displayed. Memo • When the LED pointer is turned on, the presser foot height is automatically adjusted according to the fabric thickness. • If is pressed again, the fabric thickness is remeasured and the presser foot is set to the optimum height. * The LED pointer turns off automatically by lowering the presser foot or returning to the previous page. Note • With thick elastic fabric, the position will be misaligned only at raised parts in the fabric. In this case, manually adjust the position according to the thickness of the fabric. • With fabric that has a very uneven surface such as quilting, the position is not correctly aligned. In this case, the pointer indication should be used only as a reference. B-62