Brother International LT2-B875 MKII Instruction Manual - Multi - Page 39
Caution/achtung
View all Brother International LT2-B875 MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
6-3. Winding the lower thread 6-3. Aufwickeln des Unterfadens 6. PREPARATION BEFORE SEWING 6. VORBEREITUNGEN ZUM NAHEN 6. PREPARATIFS AVANT LA COUTURE 6. PREPARATIVOS ANTES DE COSER CAUTION/ACHTUNG • Do not touch any of the moving parts or place any objects against the machine while winding the lower thread, as this may result in personal injury or damage to the machine. • Beruhren Sie beim Aufwickeln des Unterfadens keine sich bewegenden Teile und halten Sie auch keine Gegenstande an solche Teile, weil Sie sich verletzen konnen und die Nahmaschine beschadigt werden kann. O 111111 0 80% Thread wind ng amount Aufgewickelte Fadenmenge 1. Turn on the power switch. 2. Place the bobbin 0 onto the bobbin winder shaft 0. 3. Wind the thread several times around the bobbin 0 in the direction indicated by the arrow. 4. Push down the bobbin presser arm 0. 5. Raise the presser foot with the presser foot lifter. 6. Depress the treadle. Lower thread winding will then start. 7. Once winding of the lower thread is completed, the bobbin presser arm 0 will return automatically. * If the thread cannot be wound on evenly, loosen the screw 0 and move the bobbin winder guide 0 to the side where there is less thread. * Turn the adjustment screw 0 to adjust the bobbin wind- ing amount. • To increase the winding-amount: Tighten the screw. • To decrease the winding amount: Loosen the screw. Note: The amount of thread wound onto the bobbin should be a maximum of 80% of the bobbin capac- ity. 1. Schalten Sie den Netzschalter ein. 2. Setzen Sie die Spule 0 auf die Spulenachse 0. 3. Wickeln Sie den Faden einige Male in Pfeilrichtung um die Spule 0. 4. Drucken Sie den Spulenarm 0 nach unten. 5. Heben Sie den Stoffdruckerfull mit den Stoffdrucker- fulTheber an. 6. Drucken sie das Pedal, urn den Unterfaden auf die Spule aufzuwickeln. 7. Nach vollstandigem Aufwickeln wird der Spulenarm 0 automatisch zuruckgestellt. * Falls der Faden ungleichmallig aufgewickelt wird, Risen Sie die Schraube 0 und schieben Sie die Fuhrungsrolle O auf die Seite, auf der weniger Faden aufgewickelt wird. * Stellen Sie die auf die Spule aufgewickelte Fadenmenge mit der Einstellschraube 0 ein. • Zum Erhohen der Fadenmenge: Ziehen Sie die Schraube fest. • Zum Vermindern der Fadenmenge: Losen Sie die Schraube. Hinweis: Der Faden sollte hochstens zu 80% der Spulenkapazitat aufgewickelt werden. - 24 - Model No. LT2-8840 Mark II LT2-8870 Mark II