Brother International Laura Ashley Innov-ís NX2000 BOBBIN WORK INSTRUCTIO - Page 7

ENGLISH g Insert the bobbin case (gray) so that the S mark aligns with the ● mark as shown below. h Wind a decorative thread around the bobbin by hand. After winding the bobbin so it is filled as shown below (about 80%), cut the thread. a S mark b ● mark Note • The bobbin case (gray) cannot be used for sewing in any way other than bobbin work. After sewing bobbin work, refer back to the steps in "Preparing the Bobbin Thread" for removing and cleaning the bobbin case (gray), and then reinstall the standard bobbin case (black). CAUTION • Be sure to use the included bobbin or one designed specifically for this machine. Using any other bobbin may result in damage or injuries. 11.5 mm (approx. 7/16 inch) Actual size This model Other models Note • Slowly and evenly wind the thread around the bobbin. • For best results, wind the bobbin so the thread is not twisted. i Using scissors carefully trim the thread tail as close to the bobbin as possible. CAUTION • Be sure to use the bobbin case (gray) when creating bobbin work. Using any other bobbin case may result in the thread becoming tangled or damage to the machine. • Make sure that the bobbin case is correctly installed. If the bobbin case is incorrectly installed, the thread may become tangled or the machine may be damaged. a Beginning of wound thread CAUTION • If thread extends beyond the top of the bobbin too much, the thread may become tangled or the needle may break. 5