Brother International Laura Ashley Innov-ís NX2000 BOBBIN WORK INSTRUCTIO - Page 8

j Install the bobbin wound with thread. Whether or not tension should be applied to the bobbin thread depends on the type of thread used. ■ When tension is applied to the bobbin thread Insert bobbin into bobbin case so the thread unwinds from the left side. Then correctly pass the thread through the tension spring as shown below. ■ When tension is not applied to the bobbin thread If the bobbin thread in the trial stitching is too tight and adjusting the bobbin case tension does not help, do not pass the thread through the tension spring. Hold the bobbin with your left hand so the thread unwinds from the right side and hold the end of the thread with your right hand. a Tension spring CAUTION • When winding the bobbin, make sure the thread is not frayed. Sewing with frayed thread may result in the thread catching on the tension spring of the bobbin case, the thread becoming tangled or damage to the machine. • Do not guide the bobbin thread through the groove in the needle plate cover, otherwise the lower threading will not be done correctly. k Pull out about 8 cm (approx. 3 inches) of bobbin thread. l Turn on the sewing machine, and then press . → The screen changes, and all keys and operation buttons are locked. Note • If "OPENING DISPLAY" in the Settings Screen is turned "ON" press anywhere on the LCD screen before pressing the icon. 6