Brother International Laura Ashley Innov-ís NX2000 BOBBIN WORK INSTRUCTIO - Page 9

m Lightly hold the end of the upper thread, and then turn the handwheel toward you so the mark on the handwheel aligns with the line on the machine. r Install the needle plate cover and the cord guide bobbin cover (for bobbin work and attaching cords). For details on installing the needle plate cover, refer to "Cleaning the Race" in the Operation Manual. ENGLISH n Gently pull the upper thread to pull up the bobbin thread through the needle plate. a Needle plate cover b Cord guide bobbin cover (for bobbin work and attaching cords) CAUTION • When creating bobbin work, use the cord guide bobbin cover (for bobbin work and attaching cords), otherwise the thread may become tangled or the needle may break. → A loop of the bobbin thread comes out through the hole in the needle plate. o Use the presser foot lever to raise the presser foot. p Insert tweezers through bobbin thread loop and pull bobbin thread above the needle plate. q Align the upper thread and bobbin thread, and then pull out about 10 cm (approx. 4 inches) of the threads and pass them under the presser foot toward the rear of the machine. Note • When installing the needle plate cover, do not allow it to pinch the thread. s Install the flat bed attachment. Note • When installing the flat bed attachment, do not allow it to pinch the thread. t Press or screen. in the → All keys and operation buttons are unlocked, and the previous screen is displayed. Note • When the bobbin thread is replaced with a new one, be sure to repeat the procedure from a, otherwise the lower threading will not be done correctly. 7