Brother International MFC-9450CDN Users Manual - English - Page 144
Comm.Error, Connection Fail, Cooling Down, Wait for a while, Cover is Open, Disconnected, Document Jam - drum end soon
UPC - 012502622154
View all Brother International MFC-9450CDN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
Error Message Cause Action Comm.Error Poor telephone line quality caused a communication error. Send the fax again or connect the machine to another telephone line. If the problem continues, call the telephone company and ask them to check your telephone line. Connection Fail You tried to poll a fax machine Check the other fax machine's polling setup. that is not in Polled Waiting mode. Cooling Down Wait for a while The temperature of the drum unit or toner cartridge is too hot. The machine will pause its current print job and go into cooling down mode. During the cooling down mode, you will hear the cooling fan running while the LCD shows Cooling Down, and Wait for a while. Make sure that you can hear the fan in the machine spinning and that the exhaust outlet isn't blocked by something. If the fan is spinning, remove any obstacles that surround the exhaust outlet, and then leave the machine turned on but do not use it for several minutes. If the fan is not spinning follow the suggestions below. Turn off the machine's power switch and then turn it on again. If the error message continues leave the machine for several minutes and then try it again. (The machine can be turned off for up to 4 days without losing faxes stored in the memory.) Cover is Open The front cover is not closed completely. Close the front cover of the machine. Cover is Open The back cover is not closed completely. Close the back cover of the machine. Disconnected The other person or other Try to send or receive again. person's fax machine stopped the call. Document Jam The document was not inserted or fed properly, or the document scanned from the ADF was too long. See Document jams on page 133 or Using the ADF (automatic document feeder) on page 18. DR Mode in Use The machine is set to Distinctive Ring mode. You cannot change the Receive Mode from Manual to another mode. Set Distinctive Ring to Off. (See Turning off distinctive ring on page 48.) Drum End Soon The drum unit is near the end of its life. Use the drum unit until you have a print quality problem; then replace the drum unit with a new one. (See Replacing the drum unit on page 171.) The drum unit counter was not reset when a new drum was installed. Press Menu, 8, 4, and then a or b to choose Drum. Press OK and press 1 to reset the drum unit counter. Drum Error The corona wires on the drum unit needs to be cleaned. Clean the four corona wires on the drum unit. (See Cleaning the corona wires on page 151.) 128