Brother International NC2200W Network User Guide - Page 66
the NC-2200w back to the default setting and try from the initial
View all Brother International NC2200W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
4 Print the Network configuration page of the NC-2200w and check if the settings such as wireless and IP address settings are correct for your network. The problem may be the result of mismatched wireless setting, or mismatched or duplicate IP address. Verify that the Wireless settings and the IP address are correctly loaded into the NC-2200w. And make sure that no other nodes on the network have this IP address. 5 Try pinging the NC-2200w from the host operating system command prompt with the command: ping ipaddress Where the ipaddress is the NC-2200w IP address (note that in some instances it can take up to a few minutes for the NC2200w to load its IP address after setting the IP address or powered on). 6 If you have tried 4 or 5 above and it does not work, then reset the NC-2200w back to the default setting and try from the initial setup again. For the information how to reset to the factory default setting see Test Button on page 1-4. 7 Check if a personal firewall such as ICF for Windows® XP is running on your computer. If it is running, temporarily turn it off and try again. TROUBLESHOOTING 6 - 8