Brother International XL-2027 Users Manual - English - Page 17
Monogramming, Embroidering, Cloth, guide
View all Brother International XL-2027 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
29 Monogramming and Embroidering Pattern 4 or 5 or 6 Stitch Length At any position Foot Remove Others Darning plate Nre PREPARATION FOR MONOGRAMMING AND EMBROIDERING 1. Place the darning plate on the needle plate. 2. Set your sewing machine as per the above instructions. 3. Draw lettering (for monogramming) or design (for embroidering) on the right side of the fabric. 4. Stretch work between embroidery hoops as firmly as possible. 5. Place the work under the needle and lower the presser bar. 6. Pull the lower thread up through the work at starting position by turning balance wheel and make a few holding stitches. 6. Hold the hoop with thumb and forefingers of both hands while pressing the fabric with middle and third fingers and supporting the outside of hoop with smaller finger. ejetet c e , - , ,- ,L . MONOGRAMMING 1. Sew, moving hoop slowly along the lettering at the same speed. 2. Secure with a few straight stitches. (NOTE: These instructions also apply to embroidering.) EMBROIDERING 1. Stitch the outline of the design by moving the embroidery hoop accordingly. 2. Fill in design stitch from the outline of the design to the inside and from inside to edge of the outline alternately until design is completely filled in. Keep stitching close together. NOTE: A long stitch is made by moving the embroidery hoop rapidly and a short stitch is made by moving it slowly. Cloth guide Using cloth guide will help to sew parallel straight at edge of material. Attach cloth guide by placing it over the hole on the right side of needle plate. Put thumb screw through guide slot, adjust to desired distance and secure by turning thumb screw. 30