Brother International XL-2027 Users Manual - English - Page 5

Electronic display 5 MESSAGE i MESSAGE MIR Message key Light Heavy LCD adjuster Pattern name you selected is automatically displayed in the Liquid Crystal Display (LCD). Touch MESSAGE key which is located at below side of LCD for sewing guidance. The guidance message runs three times and automatically back to pattern name. When the machine is not properly set and a correction, is required, warning messages appear on the display and instruct you to correct. 1. When you set bobbin winder pin to right for bobbin winding, machine only accept bobbin winding and message of "BOBBIN WINDING" appears. 2. When you set machine at buttonhole and buttonhole lever is not pulled down, a message of "LOWER BH LEVER" appears. Stitch length dial STITCH LENGTH II y 3 Fine Coarse Reverse sewing button Foot controller Sew-light Depending on the stitch selected, you may need to adjust the stitch length. The numbers marked on the dial represent the stitch length. THE HIGHER THE NUMBER, THE LONGER THE STITCH. The "0" means the material does not feed. The "F" area is used for making a SATIN stitch (closed stitch) for buttonhole and decorative stitches. Reverse sewing button Foot controller To sew in reverse, push the button as far as it goes. Hold the button in this position until you wish to sew forward. When the button is released, it will spring back in original position and the machine will sew forward. Reverse sewing is used for backtacking and reinforcement of seams. When the foot controller is depressed lightly, the mach1ne will run at a low speed. When the pressure on the foot controller is increased, the machine will pick up the speed. When the foot controller is released, the machine will stop. Care should be taken that nothing is placed on the foot controller when the machine is not in use. Sew-light switch To turn the sew-light on or off, push the sew-light switch. 6