Brother International XL-2027 Users Manual - English - Page 20
Performance, check
View all Brother International XL-2027 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Performance check list 35 Whenever sewing difficulty is encountered, review the section of the instruction book that explains the operation you are performing to make sure you are using the machine correctly. If the problem still exists, the following check list may help you correct it. If you still have difficulties, contact your nearest service center. UPPER THREAD BREAKS LOWER THREAD BREAKS SKIPPED STITCHES LOOP IN SEAM Upper threading No Upper thread is is not correct. tangled. No Upper thread tension is too tight. No Spool of thread is not correctly set. No N0o.1 The combina- Needle is bent or tion of needle/ not sharp. thread/fabric is wrong. No I "-Page 11 1.--Page 11 111.- Page13 . Page 9 1-0 -Page 31 N.-Page 14 / Lower thread is tangled. No Bobbin is not threaded pro- perly in the shuttle hook. No Lower thread tension is too tight. No Page12 1--N.-Page 10 Page 13 Needle is not correctly inserted. No -N.- Inferior needle is used. No The combination of needle/ thread/ fabric is wrong. No Lint is clinging under the needle plate. No Threading is not correct. No - I---p-Page 31 .-Page 31 N. Page 14 -N.-Page 33 ro. Page 11 Thread tension No is not correct. N. Page 13 FABRIC PUCKERS FABRIC DOES NOT FEED PROPERLY NEEDLE BREAKS Thread tension No Threading is not No Wrong needle is too tight. correct. is used. No The combination of needle/ No thread/fabric is wrong. N.--Page 13 1.-Page 11 N.-Page 31 N.Page 14 Stitch length is set at no feeding. No -N.- The combination of needle/ thread/fabric is wrong. No Inferior needle is used. No Thread is tangled. No r.Page s.-Page 14 N.-Page 31 N. Pagel 0, 11 Needle is not correctly inserted. No Inferior needle is used. No The combination of needle/ thread/ fabric is No Fabric is pulled excessively. No ► wrong. Page 31 i.-Page 31 I a.-Page 14 MACHINE IS NOISY OR SLOW Lint is clinging under needle plate. No Insufficient oiling No - -Page33 -N.-Page34 MACHINE DOES NOT START Use foot controller. No Ir Power supply plug No is removed from outlet. Clutch release knob is not tightened. No - • I- .-Page 6 .-Page 9 36