Brother International XL-2230 Users Manual - English - Page 13
Replacing the Needle - sewing machines
View all Brother International XL-2230 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
KNOWING YOUR SEWING MACHINE Replacing the Needle CAUTION ● Turn the main power switch off before you change the needle. If you leave the main power on and step on the foot controller, the machine will start and you may be injured. ● Only use sewing-machine needles for home use. Other needles may bend or break and cause injury. ● Never sew with a bent needle. A bent needle will easily break and cause injury. • Do not use a lot of force when loosening or tightening the needle clamp screw, otherwise certain parts of the sewing machine may be damaged. With the flat side of the needle toward the 5 back of the machine, put the needle in until it touches the needle stopper. 1 2 Remove the power supply plug from the 1 outlet. Raise the needle bar to its highest position by 2 turning the balance wheel counterclockwise. Lower the presser foot lever. 3 1 Needle stopper 2 Needle While holding the needle with your left hand, 6 use the screwdriver to tighten the needle clamp by turning it clockwise. Put the twin needle in the same way. 1 Presser foot lever Hold the needle with your left hand, and then 4 use a screwdriver to turn the needle clamp screw counterclockwise to remove the needle. 1 2 1 Screwdriver 2 Needle clamp screw CAUTION ● Make sure you push in the needle until it touches the stopper, and securely tighten the needle clamp screw with a screwdriver. If the needle is not in fully, or if the needle clamp screw is loose, the needle may break or the machine may be damaged. 12