Brother International XL-2600 Owner's Manual (Español) - Spanish - Page 49

Symptom Possible cause How to put it right Reference The area around the hole in the needle plate is scratched. Replace the needle plate. Contact your retailer or the nearest authorized service center. - The upper The area around the hole in the presser foot is scratched. Replace the presser foot. Contact your retailer or the nearest authorized service center. - thread breaks. The bobbin case is scratched, or has a burr on it. Replace the bobbin case. Contact your retailer or the nearest authorized service center. - You have not used a bobbin that has been designed for this machine. Incorrect bobbins will not work properly. Only use a bobbin that has been designed for this machine. page 16 You have not wound the bobbin thread properly. Wind the bobbin properly. page 16 The bobbin is scratched or does not turn smoothly. Replace the bobbin. - The lower thread is tangled or breaks. The thread is tangled. You have not used a bobbin that has been designed for this machine. Remove the tangled thread and clean the bobbin case. Incorrect bobbins will not work properly. Only use a bobbin that has been designed for this machine. page 44 page 16 Bobbin is set incorrectly. Reset the bobbin thread correctly. page 18, 19, 20 You have not threaded the upper thread properly. Correct the upper threading. page 21 You have not wound the bobbin thread properly. Wind the bobbin thread properly. page 16 You have not threaded the right combination of thread and needle for the fabric you are using. Choose a thread and needle that are appropriate for the type of fabric. page 26 The thread ten- You have not attached the presser sion is incorrect. foot holder properly. Attach the presser foot holder properly. - 6 The thread tension is incorrect. Adjust the tension of the upper thread. page 25 You have not used a bobbin that has been designed for this machine. Incorrect bobbins will not work properly. Only use a bobbin that has been designed for this machine. page 16 Bobbin is set incorrectly. Reset the bobbin thread correctly. page 18, 19, 20 You have not threaded the upper thread properly or fitted the bobbin properly. Thread the upper thread and wind the bobbin thread properly. page 18, 19, 21 You have not fitted the spool properly. Fit the spool properly. page 21, 25 The fabric is wrinkled. You have not used the right combination of fabric, thread and needle. Choose a thread and needle that are appropriate for the type of fabric. page 26 The needle is bent or blunt. Replace the needle. page 8 If you are sewing thin fabric, the stitch is too thick. Sew with stabiliser material under the fabric. - The thread tension is incorrect. Adjust the tension of the upper thread. page 25 47