Bushnell Natureview 8x40 Instruction Manual - Page 18
Step 1, Step 2, Step 3, Step 4, Step 5, Step 6, Step 7
View all Bushnell Natureview 8x40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
5:30 and 7:00 PM. No Field Scan recording would occur from 8AM to 5:30PM, or from 7PM to 6AM. Remember, Field Scan recording is independent of normal triggers due to animal activity-even if no animals enter the IR sensor coverage zone, an image or video will still be captured every 15 minutes during the block(s) of time. If an animal triggers the camera "in between" the 15 minute intervals, it will be recorded, same as it would if you had setup the camera with Field Scan turned Off. Note: Field Scan settings of frequent intervals and/or long periods between start and stop time can reduce battery life. (Step 1)-set Field (Step 2)-select Field (Step 3)-set Field Scan Mode to "On" Scan "A" (press OK) Scan "A" Stop & Start Steps 4 & 5 are optional (only required if you want to set up a second block of Field Scan recording with different stop and start times) (Step 4) (opt)-select Field (Step 5) (opt)-set Field Scan "B" (press OK) Scan "B" Stop & Start Note: the Interval Setting sets the timing between each image for both Field Scan "A" and "B" recording blocks. (Step 6)-select Field Scan "Interval" (Step 7)-set Field Scan Interval 18