Campbell Scientific CR3000 CR3000 Micrologger - Page 139
PortSet, ExciteV, Table 18., Pipeline Mode Task Priorities
View all Campbell Scientific CR3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
Section 7. Installation the sequence in which the instructions are executed may not be in the order in which they appear in the program. Therefore, conditional measurements are not allowed in pipeline mode. Because of the precise execution of measurement instructions, processing in the current scan (including update of public variables and data storage) is delayed until all measurements are complete. Some processing, such as transferring variables to control instructions, like PortSet() and ExciteV(), may not be completed until the next scan. When a condition is true for a task to start, it is put in a queue. Because all tasks are given the same priority, the task is put at the back of the queue. Every 10 ms (or faster if a new task is triggered) the task currently running is paused and put at the back of the queue, and the next task in the queue begins running. In this way, all tasks are given equal processing time by the datalogger. All tasks are given the same general priority. However, when a conflict arises between tasks, program execution adheres to the priority schedule in table Pipeline Mode Task Priorities (p. 139). Table 18. Pipeline Mode Task Priorities 1. Measurements in main program 2. Background calibration 3. Measurements in slow sequences 4. Processing tasks 7.7.3.6.2 Sequential Mode Sequential mode executes instructions in the sequence in which they are written in the program. Sequential mode may be slower than pipeline mode since it executes only one line of code at a time. After a measurement is made, the result is converted to a value determined by processing arguments that are included in the measurement command, and then execution proceeds to the next instruction. This line-by-line execution allows writing conditional measurements into the program. Note The exact time at which measurements are made in sequential mode may vary if other measurements or processing are made conditionally, if there is heavy communications activity, or if other interrupts, such as engaging CF card (CRD: drive) or Campbell Scientific mass-storage media (USB: drive), occur. When running in sequential mode, the datalogger uses a queuing system for processing tasks similar to the one used in pipeline mode. The main difference when running a program in sequential mode is that there is no pre-scheduling of measurements; instead, all instructions are executed in their programmed order. A priority scheme is used to avoid conflicting use of measurement hardware. The main scan has the highest priority and prevents other sequences from using measurement hardware until the main scan, including processing, is complete. Other tasks, such as processing from other sequences and communications, can occur while the main sequence is running. Once the main scan has finished, other sequences have access to measurement hardware with the order of priority being the background calibration sequence followed by the slow sequences in the order they are declared in the program. 139