Campbell Scientific CR3000 CR3000 Micrologger - Page 49

Section 4. Quickstart Tutorial Figure 17: Short Cut thermocouple wiring 4.2.4.3 Procedure: (Short Cut Steps 10 to 11) Historical Note In the space-race era, measuring thermocouples in the field was a complicated and cumbersome process incorporating a thermocouple wire with three junctions, a micro-voltmeter, a vacuum flask filled with an ice slurry, and a thick reference book. One thermocouple junction was connected to the microvoltmeter. Another sat in the vacuum flask. The third was inserted into the location of the temperature of interest. When the temperature settled out, the micro-voltmeter was read. This value was then looked up on the appropriate table in the reference book to determine the temperature. Then along came Eric and Evan Campbell. Campbell Scientific designed the first CR7 datalogger to make thermocouple measurements without the need for vacuum flasks, third junctions, or reference books. Now, there's an idea! Nowadays, a thermocouple consists of two wires of dissimilar metals, such as copper and constantan, joined at one end. The joined end is the measurement junction; the junction that is created when the thermocouple is wired to the CR3000 is the reference junction. When the two junctions are at different temperatures, a voltage proportional to the temperature difference is induced into the wires. The thermocouple measurement requires the reference junction temperature to calculate the measurement junction temperature using proprietary algorithms in the CR3000 operating system. 10. Click 3. Outputs to advance to the next step. 49