Canon 4454B001 Instruction Manual - Page 105
Special Recording Modes
View all Canon 4454B001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
Special Recording Modes Recording 3 Available Intervals* 1 sec 2 sec 3 sec 4 sec 5 sec 6 sec 7 sec 8 sec 10 sec 15 sec 20 sec 30 sec 40 sec 50 sec 1 min 2 min 4 min 5 min 6 min 7 min 8 min 9 min 10 min * In the camcorder's menu, seconds are indicated by [sec] and minutes are indicated by [min]. 9 sec 3 min Activating Interval Recording Mode and Recording 1 Open the [Special Rec] submenu. [J Other Functions] [Special Rec] 2 Select [Interval Rec] and then press SET. • [INT STBY] appears at the top of the screen (with [INT] flashing). 3 Press the START/STOP button to begin recording. • The camcorder automatically records the set number of frames at the set interval. • The tally lamps illuminate. • [INT STBY] changes to [N INT REC] while recording frames and [N INT STBY] while between intervals. 4 Press the START/STOP button again to stop recording. • All of the recorded frames are joined together into one clip. • The tally lamps go out and [INT STBY] appears at the top of the screen (with [INT] flashing). NOTES • You can use only one special recording mode at a time. • While recording, you cannot change the interval or number of frames. • Some frames at the point the recording was stopped may be recorded and added to the end of the clip. • Interval recording mode will be deactivated if the special recording mode is changed or turned off. It will be deactivated also if you change the [J Other Functions] [Bit Rate/Resolution] or [Frame Rate] setting. • The time code advances by the number of frames recorded. If the running mode of the time code (0 84) is set to [Free Run] or the time code is input from an external source (b only), the running mode will switch to [Rec Run] during special recording mode. When special recording mode is deactivated, the running mode will return to its previous setting. • b During special recording mode, the time code signal will not be output from the TIME CODE terminal or HD/SD SDI terminal. [J Other Functions] [Special Rec] [Off] 105