Canon CINE-SERVO 50-1000mm T5.0-8.9 PL User Manual - Page 42

1 NOMENCLATURE 1 NOMENCLATURE ᶋ ᶌ ᶍ ᶎ ᶏ ᶐ ᶑ ᶒ ᶓ ᶔ PL Mount Lens Only ᾛ ᾦ ᶖ ᶕ ᾧ ① Iris Gain Adjusting Trimmer ② Focus Ring A ③ Focus Ring B ④ Max. Zoom Speed Adjusting Volume ⑤ Instant Auto-Iris Switch ⑥ Iris Operation Mode Change-over Switch ⑦ Zoom Rocker Seesaw ⑧ RET Switch (Video Return Switch) ⑨ VTR Switch ⑩ AUX Switch ⑪ Flange Back Lock Screw/Flange Back Adjusting Ring ⑫ Macro Button/Macro Ring ⑬ Extender Switching Lever ⑭ MEMO Switch (Memory Switch) ⑮ Iris Ring ⑯ Zoom Lever/Zoom Ring ⑰ Lens Holder ⑱ Lens Cable Connector (12-pins) NOTE) PL mount lens only ⑲ Zoom/Focus Remote, Iris Remote, Virtual Connectors (20-pin) NOTE) Only connector ˒ can be used as the iris remote or virtual output port. Use these connectors to connect the control accessory (equipped with a 20 pin connector) for zooming or focusing. Connector ★ has also a function to operate the iris through a focus control accessory and a dedicated cable and a function to interface with various virtual systems. It can output each positioning signal of zoom, focus, and iris. ⑳ Zoom/Focus Operation Change-over Knob ㉑ Hood Lock Knob ㉒ Attachment Holder Contact Plate ㉓ Tie Cable Information Display (Digital Drive Unit) ᶃ ᶄ ᶅ ① Display Switch Used to turn the display ON/OFF. ② Display It turns off if left for 2 minutes without operation. ③ Control key Used to move the cursor up/down/left/right. Press the center to confirm. For the operation of the digital drive unit, refer to the "Information Display Manual" on the CD-ROM. E2