Canon CanoScan 4400F Quick Start Guide Instructions - Page 8

English - film scan

Get Canon CanoScan 4400F PDF manuals and user guides View all Canon CanoScan 4400F manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

English 4 Insert the film into the Film Guide. Place the film face down with the frames in reverse order. Scanning Film • Use a blower brush to remove any dust from the film, which will affect the image quality, and take care to hold the film by its edges to avoid transferring dirt or fingerprints to it. • Do not block the calibration slot on the Film Guide when scanning film. Colors will not be scanned correctly if the calibration slot is obstructed. • Close the Film Guide securely. Press lightly until it clicks into place. How to Use the Shield When scanning short or curled film, extra light may enter through gaps and produce bands of color around the edges of the scanned image. If this occurs, use the supplied shield as shown in the figure. 5 Set the Film Guide to the document cover, and a b close the document cover. Hold the document cover and a insert the bottom edge of the Film Guide into the bottom groove in the document cover, and then b tilt the top of the Film Guide up into the document cover until it locks securely into place with a click. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
Scanning Film
7
English
4
Insert the film into
the Film Guide.
Place the film face
down with the frames
in reverse order.
5
Set the Film Guide to the
document cover, and
close the document
cover.
Hold the document cover and
a
insert the bottom edge of
the Film Guide into the
bottom groove in the
document cover, and then
b
tilt the top of the Film Guide
up into the document cover
until it locks securely into
place with a click.
• Use a blower brush to remove any dust from the film, which will affect the image quality,
and take care to hold the film by its edges to avoid transferring dirt or fingerprints to it.
• Do not block the calibration slot on the Film Guide when scanning film. Colors will not
be scanned correctly if the calibration slot is obstructed.
• Close the Film Guide securely. Press lightly until it clicks into place.
How to Use the Shield
When scanning short or curled film, extra light
may enter through gaps and produce bands of
color around the edges of the scanned image.
If this occurs, use the supplied shield as shown in
the figure
.
a
b