Canon CanoScan D2400UF CanoScan D1230U/D2400U Plug-in Module CS-U 4.1 for Mac - Page 27

STEP 1 Shut off lamp time This option turns off the scanner lamp, which is otherwise continually on while the power is on, to save power if it remains idle for a specified length of time. It can be set to any interval of 4 minutes between 4 and 56 minutes (the actual shut off time may vary slightly from the specified interval). This setting is automatically set to 12 minutes when Plug-in Module CS-U is first installed. Click the up or down arrow in the spinbox to increase or decrease the number setting or enter a number directly into the entry box Reset Default Settings Returns the preference settings and all other settings to the factory default settings. The tables list the major default settings. Scan Mode Magnification Unit Basic Resolution(Platen) Basic Resolution(Film) Control Panel Position Image Unsharp Mask Descreen Shut of Lamp Time Film Type 24bit Color 100% Pixels 72 dpi 600 dpi Center Recommended On Off 12minutes Color Negative Close Plug-in After Scan This setting determines whether or not Plug-in Module CS-U closes automatically after completion of the scanning job. After you install Plug-in Module CS-U, this setting is set to off. To turn this feature on, open the [Preferences] menu and select [Close plug-in after scan]. Platen/Film When a film adapter unit (FAU-S12/S13) is attached to the scanner, the [Film] option in the pull-down menu can be selected. Select either [Platen] or [Film] to make the respective scanning method effective, which is indicated by a check mark in the pull-down menu. Caution • When switching between the [Platen] and [Film] options, the scanner has to adjust the lamp output, which may require a few moments to take effect. 27