Canon LV-7105 Service Manual - Page 83
V_SW., P.F.C., control, LAMP.DET, Switching power, supply, Check that the FAN DRIVE
![]() |
View all Canon LV-7105 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Part 4: Troubleshooting IIC BUS TEMP. SENSOR IC2831 Abnormal temperature detection on the Main board. Check that the FAN DRIVE signal at pin 19 of IC1804 is correct. H : Power ON S6V 15V 5V 5V_SW. Q671, Q681 PSDA PSDA TEMP. BOARD TEMP. SENSOR IC2832 Abnormal temperature detection inside of the projector. Is projection of lamp cover inside broken or not fitting correctry ? Check the interlock switch (SW904) and lamp cover. SW904 -- OPEN : abnormal Interlock switch SW904 SW902 FAN CONT1 FAN_DRIVE Check signal at pin 5 of T651 Is thermal switch (SW902) operating ? If peripheral temperatures at the lamp house reaches 100˚C, the thermal switch turns off. SW902 -- OPEN: abnormal IC2641 ~ IC2681 Switching power supply Abnormal temperature detection at the periphery of P.F.C. circuit 7 TSW611 P.F.C. control P.F.C. CB1 LAMP BALLAST UNIT LAMP_BST_SW LAMP_ERR LAMP_SW When an abnormal temperature is detected at the periphery of lamp driver circuit, the voltage of this line comes HIGH. LAMP.DET CB2 (Error: H) K8CC-1 Check that the thermal switch (TSW611) is operating. If temperature at peraiphery of P.F.C. circuit reaches 95˚C, TSW611 turns on. TSW611 -- OPEN: Normal (Power-On: H) CB2 LAMP SW. K8CC-4 LAMP 4-5
![](/manual_guide/products/canon-lv7105-service-manual-b5e1e53/83.png)