Canon LV S3 LV-S3_Inst.pdf - Page 14
Remote Control Battery Installation, Attaching the Lens Cover
View all Canon LV S3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Preparation Remote Control Battery Installation 1 Remove the battery compartment lid. Pull up and remove the lid. 2 Slide the batteries into the compartment. 3 Replace the compartment lid. Two AAA size batteries For correct polarity (+ and -), be sure battery terminals are in contact with pins in compartment. To insure safe operation, please observe the following precautions : - Use (2) AAA, SUM-4 or R03 type alkaline batteries. - Replace two batteries at the same time. - Do not use a new battery with a used battery. - Avoid contact with water or liquid. - Do not expose the remote control unit to moisture, or heat. - Do not drop the remote control unit. - If a battery has leaked on remote control unit, carefully wipe case clean and install new batteries. - Risk of explosion if battery is replaced by an incorrect type. - Dispose of used batteries according to the instructions. Attaching the Lens Cover 1 Thread the string through the hole on the lens cover and then tie a knot in the string to secure it in place. 2 Thread the other end of the string through the hole at the bottom of the projector. Then pass the lens cover through the resulting loop of the string. Tie a knot in the string to secure it in place. 14