Canon LV S3 LV-S3_Inst.pdf - Page 40
Maintenance - bulb
View all Canon LV S3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Maintenance Lamp Replacement Lamp Replace When the life of the projection lamp draws to an end, LAMP REPLACE indicator lights yellow. If this indicator lights yellow, replace the projection lamp with a new one promptly. TOP CONTROL SET MENU VOL + LAMP REPLACE WARN This indicator lights yellow when the life of the projection lamp draws to an end. Allow a projector to cool, for at least 45 minutes before you open Lamp Cover. The inside of a projector can become very hot. CAUTION For continued safety, replace with a lamp assembly of the same type. Do not drop a lamp assembly or touch a glass bulb! The glass can shatter and may cause injury. Follow these steps to replace the lamp assembly. 1 Turn off the projector and disconnect AC plug. Allow the projector to cool at least for 45 minutes. 2 To remove the lamp cover, remove the screw with a screwdriver . 3 Remove the two screws with a screwdriver and pull out the lamp assembly by grasping the handle. 4 Replace the lamp assembly with a new one and tighten the two screws back into the position. Make sure that the lamp assembly is set properly. Replace the lamp cover and tighten the screw. 5 Connect the AC Power Cord to the projector and turn on the projector. 6 Reset the Lamp Replace Counter. Refer to "Lamp Replace Counter" on the next page . Note : Do not reset the Lamp Replace Counter when the projection lamp has not been replaced. Screws Screw Lamp Cover Handle Lamp Assembly ORDER REPLACEMENT LAMP Replacement Lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer. • Model No. of your projector : • Replacement Lamp Type No. : LV-S3 LV-LP20 (610 308 3117) 40