Canon LV S3 LV-S3_Inst.pdf - Page 15

Installation Connecting to a Computer IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA) Monitor Output Audio Output USB port VGA Cable Audio Cable (Stereo) ✽ USB Cable ✽ RESET VIDEO IN S-VIDEO IN SERVICE PORT If you wish to use Page buttons on the remote control unit, connect USB port of your computer to the USB socket of the projector with a USB cable. ( P10, P38 ) When using the provided Presentation Remote Receiver, this connection is not necessary. RGB IN / COMPUTER / COMPONENT IN COMPONENT AUDIO AUDIO IN IN Terminals of the Projector Note : When connecting the cable, the power cords of both the projector and the external equipment should be disconnected from AC outlet. Turn the projector and peripheral equipment on before the computer is switched on. Cables used for connection • VGA Cable ( HDB 15 pin ) • Audio Cable ( Mini Plug (stereo) ) ✽ • USB Cable ✽ • MAC Adapter ( For Macintosh ) ✽ ✽ Not supplied. MAC ADAPTER (Not supplied)✽ A Macintosh adapter may be required when you use a Macintosh computer. Set switches as shown in the table below depending on RESOLUTION MODE that you want to use before you turn on projector and computer. ON OFF ON DIP 123456 1 2 3 4 56 13" MODE (640 x 480) ON ON OFF OFF OFF OFF 16" MODE (832 x 624) OFF ON OFF ON OFF OFF 19" MODE (1024 x 768) OFF ON ON OFF OFF OFF 21" MODE (1152 x 870) ON ON ON ON OFF OFF 15