Canon PIXMA MX492 User Manual - Page 220

Printing/Scanning with the Access Point Mode Print/Scan with the access point mode following the procedure below. 1. Connect an external device such as a computer or a smartphone to the machine via wireless LAN. Perform wireless LAN settings with your external device, then assign the access point name (SSID) specified for the machine as a destination. Note • For details on how to perform wireless LAN settings with an external device, refer to the device's instruction manual. • When a WPA2-PSK (AES) password is valid on the machine, entering the password is required to connect an external device to the machine via wireless LAN. Enter the password specified for the machine. 2. Start printing or scanning from an external device such as a computer or a smartphone. Note • For details on how to print or scan from an external device such as a computer or a smartphone via wireless LAN, refer to the device's or application's instruction manual. How to terminate the Access Point Mode In environments that the machine is usually connected with the computer over the wireless LAN, set the machine to the wireless LAN connection following the procedure below when you finish using the machine with the access point mode temporarily. 1. Press the Setup button. The Setup menu screen is displayed. 2. Use the button to select Device settings, then press the OK button. The Device settings screen is displayed. 3. Use the button to select LAN settings, then press the OK button. 4. Use the button to select Change LAN, then press the OK button. 5. Use the button to select Wireless LAN, then press the OK button. If you do not use the machine over wireless LAN, select LAN inactive. Setting of the Access Point Mode Specify the settings for the access point mode following the procedure below. 1. Make sure that the machine is turned on. 220