Canon PIXMA MX492 User Manual - Page 587

Check5 Make sure that external communication devices are not placed far away from the machine. Locate your external communication device close enough to communicate with the machine. Check6 Make sure that there is no obstruction. Wireless communication between different rooms or floors is generally poor. Adjust the location of the devices. Check7 Make sure that there is no source of radio wave interference in your vicinity. If a device (e.g. microwave oven) using the same frequency bandwidth as the wireless station is placed nearby, the device may cause interference. Place the wireless station as far away from the interference source as possible. Check8 Are you trying to connect 6 devices or more? You can connect up to 5 devices using the access point mode. Cannot Print or Scan from a Computer Connected to the Network Check1 Make sure that the network settings of the computer are correct. For the procedures to set up the computer, refer to the instruction manual of your computer or contact its manufacturer. Check2 If the MP Drivers are not installed, install them. Install the MP Drivers from our website. Check3 Make sure that access control is not set to the wireless router. For the procedures to connect a wireless router and set it up, refer to the instruction manual of your wireless router or contact its manufacturer. Note • To check the MAC address or the IP address of the computer, see Checking the IP Address or the MAC Address of the Computer. 587