Canon PIXMA MX882 Network Setup Troubleshooting - Page 8
Problems during Software Installation, The Machine is Not Displayed Detected - wireless manual
View all Canon PIXMA MX882 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
ENGLISH Problems during Software Installation • When using an access point that does not support WPS, configure settings manually. For the procedure to configure settings of the machine manually, refer to "Wireless Setup Using Easy Setup" in the printed manual: Getting Started. The Machine is Not Displayed (Detected) Check A A B C B C Check 1 For a wireless connection, make sure that you follow Check 1, 2, 3, 4, 5 and 8 of "Connection Checklist" on page 15, then click Update (A). For a wired connection, make sure that you follow Check 1, 2, 6, 7 and 8 of "Connection Checklist" on page 15, then click Update (A). Check 2 Is the machine connected to a network? • To confirm the connection status, press the Setup button, then using the { } [ ] and OK buttons, select Device settings > LAN settings > Confirm LAN settings > WLAN setting list or LAN setting list. Make sure that Connection is set to Active. If the machine is not connected to a network, perform setup again by following the procedures in "Wireless Setup" and onward or "Wired Setup" and onward in the printed manual: Getting Started. • Check Check the printer settings (B), click Next (C), then click Wireless LAN Setup Information on the Check Printer Settings dialog box to display the access point information stored on your computer. Refer to the information when configuring the network setting for the machine. Wireless LAN Setup Information may not be displayed. (* Wireless connection only)