Canon PIXMA iP1500 Service Manual - Page 5

3. ERROR DISPLAY Errors are displayed by the LEDs, and ink low warnings are displayed by the Status Monitor. 3-1. Operator Call Error (LED Blinking in Orange) LED blinking Error 2 times Paper out 3 times Paper jam 4 times Ink tank not installed 5 times 8 times Print head not installed or failure has occurred in the print head. (Non-supported print head (see page 4) is installed or print head EEPROM data is abnormal.) Waste ink absorber full or platen waste ink absorber full warning (approx. 95% of the maximum capacity) Corrective action Set paper, and press the Resume/Cancel button to feed the paper. Remove the jammed paper, and press the Resume/Cancel button. Re-install the ink tanks, and close the access cover. Install the print head, and close the access cover. Or, confirm the print head is "QY6-0054-000" and perform re-installation. If not recovered, with the print head installed, power the printer off and on. Pressing the Resume/Cancel button will exit the error, and enable printing. 3-2. Service Call Error (LED Blinking in Orange and Green Alternately) LED blinking Error Corrective Action 2 times Carriage error Replace the printer as it has failed. 3 times LF error Replace the printer as it has failed. 7 times Waste ink absorber full or platen waste ink Replace the printer as it has failed. absorber full 8 times Print head temperature rise error Replace the printer as it has failed. 9 times EEPROM error Replace the printer as it has failed. 10 times No print head detected excepting print head Replace the printer as it has failed. replacement (during printing) ( 5 / 21 )