Canon VB-S805D Network Camera VB-S30D/VB-S31D/VB-S800D/VB-S805D/VB-S900F/VB-S9 - Page 49

[Camera] Setting Initial Camera Settings and External Device Name (4) [Haze Compensation Strength (Auto)] Installation Conditions Select [Mild], [Medium], or [Strong] for the haze compensation strength when [Haze Compensation] (p. 47) is set to [Auto]. When [Haze Compensation] is set to [Auto] and [Haze (1) [LED Setting] 3 Compensation Strength (Auto)] is set to [Strong], Select [Turn Off] or [Turn On] for the LED operation contrast may be strong if the subject is not obscured status on the camera. Set to [Turn Off] if you do not by haze. If this happens, set [Haze Compensation want to turn on the LED. Setting Page Strength (Auto)] to [Mild]. (2) [Image Flip] (5) [Pan/Tilt Speed Control] Select [Control at set speed] or [Control by zoom Select [Disable] or [Enable] for the orientation of the camera video. position] for the pan/tilt control mode. If [Control by zoom position] is selected, the pan/tilt speed will be slower in the telephoto zoom range, and faster in wide-angle zoom range. Note The LED will light for several seconds when booting even if the [LED Setting] is set to [Turn Off]. Important • [AGC Limit] is disabled when [Exposure] is set to [Manual], [Auto (Flickerless)], or [Auto (Flickerless 2)] in the Admin Viewer. • Minimum subject illumination may change when [AGC Limit] is set. Note • [Pan/Tilt Speed Control] can also be set in [Control for Admin] > [Pan/Tilt] (p. 141). • If [Control by zoom position] is selected, [Control for Admin] > [Pan/Tilt] will also be fixed at [Control speed by zoom position]. Day/Night (when Auto is set) (1) [Switching Brightness] Set the brightness at which Day Mode and Night Mode will be switched when [Auto] is selected in [Day/Night]. Select [Darker], [Slightly Darker], [Standard], [Slightly Brighter] or [Brighter]. Select [Darker] if you want to capture video in color as much as possible. Select [Brighter] to reduce noise. Note that this mode switches to black & white sooner. (2) [Response (sec.)] Set the time in seconds needed for judgment on switching between Day Mode and Night Mode when [Auto] is selected in [Day/Night]. Select [60], [30], [20], [10] or [5]. The mode will switch between Day Mode and Night Mode if brightness remains above or below the level set in (1) for the number of seconds specified. Select [30] or [60] if brightness changes frequently, such as when a light source passes in front of the camera. Select [5] or [10] if change in brightness is minimal. Camera Position Control (1) [Restricted to Presets] Set the camera control preset to [No Restriction] or [Preset Only]. The administrator can limit camera control by non-administrators to preset angles by selecting [Preset Only]. (2) [Camera Position without Control] Select either [Do not return to Home Position] or [Return to Home Position] as the action when no control privileges are requested by users and the home position has already been set. When [Return to Home Position] is selected and no users have control privileges, the camera moves automatically to the home position. This function requires the home position of the camera be set in advance. Set the home position using Preset Setting Tool (p. 96). External Input Device / External Output Device [Device Name] for external input device/external output device Be sure to enter each device name in order to identify the corresponding external device being connected. Enter [Device Name (alphanumeric characters)] using up to 15 characters (ASCII characters (space or printable characters) excluding the double quotation mark (")). Note The external device name set here will be shown when the Admin Viewer or included RM-Lite is used. 49