Canon iP90v Quick Start Guide - Page 86
Cannot Print Properly from the Digital Camera - power cord
UPC - 013803082128
View all Canon iP90v manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Troubleshooting Cannot Print Properly from the Digital Camera The following are the possible errors that may occur when printing directly from a digital still camera or digital video camcorder*, and the countermeasures to eliminate them. * Hereafter, a digital still camera and digital video camcorder are collectively called a digital camera or camera. Camera Error Message Printer in use Printer warming up No paper /Paper error Paper Jam Printer cover open No Print Head Waste tank (Waste ink absorber*2) full Ink tank is empty Printer error Possible Cause Try This Images are being printed from Wait until printing ends. The printer automatically starts the computer printing the images from the camera after completing the current printing. The printer is warming up Wait until warm-up ends. When it is ready, the printer starts printing automatically. No paper is loaded Load the paper in the Auto Sheet Feeder of the printer and select Continue*1 in the display on your camera. A paper jam occurrs in the printer Select Cancel in the display on your camera to cancel the print job. Remove the jammed paper, load new media, and press the RESUME/CANCEL button. The Print Head Cover is open Close the Print Head Cover. No Print Head is installed (The Install a Print Head according to the Easy Setup Instructions. POWER lamp on the printer If a Print Head has already been installed, remove it, and then flashes five times) reinstall it. The Print Head is defective (The POWER lamp on the printer flashes five times) If the problem still remains, the Print Head may be defective. Contact the Customer Care Center. The waste ink absorber*2 is nearly full The printer has a built-in waste ink absorber to hold the ink used during Print Head cleaning. This error message indicates that the waste ink absorber is nearly full. Selecting Continue*1 in the display on your camera resumes printing. Printing can be continued for a while, but printing cannot be continued when the waste ink absorber becomes full. Contact the Customer Care Center as soon as possible. Replace the ink tank with a new one Printing resumes once the Print Head Cover is closed after an ink tank replacement. You can continue printing by selecting Continue*1 in the display on your camera with the ink tank empty. But, it is recommended you replace it with a new one immediately after printing. It may damage the printer if you continue printing with empty ink tanks. The battery level is low (The POWER lamp on the printer flashes twelve times) Follow the procedure below. 1. Turn off the printer. 2. Connect the supplied Universal AC Adapter or load a charged battery. 3. Turn on the printer. An error requiring servicing Select Cancel in the display on your camera to cancel the print might have occurred (The job. POWER lamp on the printer Disconnect the cable connected to the camera, turn off the flashes alternately orange and printer, and unplug the power cord of the printer from the green) outlet. Leave the printer for a while, plug the power cord of the printer back in the outlet, turn on the printer, and connect the camera to the printer. If the error persists, contact the Customer Care Center. *1 To resume printing, you can press the RESUME/CANCEL button on the printer instead of selecting Continue. *2 The waste ink absorber absorbs ink used during cleaning. 82