Canon iPF610 iPF610 User Manual - Page 707

Other problems Depression on the leading edge is left Cause Keeping a roll in the printer for a long time without printing on it may leave a depression on the leading edge. Corrective Action When printing quality is most important, we recommend setting TrimEdge Reload to On or Automatic so that the paper edge is automatically cut before printing. Roller marks are left across the trailing edge of paper Cause A document was removed after printing from the Front Paper Feed Slot without pressing the Load/Eject button. Corrective Action Following the instructions, press the Load/Eject button, remove the paper, and then press the OK button. Wipe away any soiling on the rollers. (→P.644) (→P.647) The printer does not go on Cause The printer is unplugged. The specied voltage is not supplied. Corrective Action Plug the power cord into the outlet, and then turn on the printer. Check the voltage of the outlet and breaker. For information on the specied voltage, see "Specications". (→P.74) Roll paper cannot be inserted into the Paper Feed Slot Cause The roll paper is warped. Corrective Action Straighten out curls and reload the roll. The roll was pulled out by force when it had been advanced before printing, and this action closed the Paper Feed Slot. Hold down the Load/Eject button for a while and reload the roll. Cannot load sheets in the tray Cause The paper source selection is incorrect. Corrective Action Press the Feeder Selection button to activate the Paper Tray lamp. The Front Tray Guides are in the Front Paper Feed Slot. Cause Paper cannot be ejected because the roll was advanced when the Front Tray Guides were in the Front Paper Feed Slot. Corrective Action On the Control Panel, momentarily select POP Board on the screen for selection of the media type. The Front Paper Feed Slot will rise, so lift the Vertical Paper Guides and store them toward the front. Troubleshooting 693