Canon imagePROGRAF GP-2000 imagePROGRAF GP-4000 GP-2000 series User Manual - Page 98
Roll Holder Lock
View all Canon imagePROGRAF GP-2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
Note • If any cut sheet has been fed, or roll paper that will not be used has been fed from Roll 2 (Lower), a message is shown requesting you to remove it. After following the instructions on the screen to remove the paper, redo the operation. • If roll paper is loaded in Roll 2 (Lower) but Roll 2 (Lower) is not selected as the paper source, a message asking you whether or not to change paper is displayed. Tap Replace paper, remove the paper, and go to the next step. 2. Change Roll Holder Lock switch on roll unit to release position. 3. Hold flanges (A) so that holder stopper is on left, align roll holder shaft with roll holder slot left and right guide grooves (B), and load. 98
Note
•
If any cut sheet has been fed, or roll paper that will not be used has been fed from Roll 2 (Lower),
•
a message is shown requesting you to remove it.
After following the instructions on the screen to remove the paper, redo the operation.
•
If roll paper is loaded in Roll 2 (Lower) but Roll 2 (Lower) is not selected as the paper source, a
•
message asking you whether or not to change paper is displayed.
Tap
Replace paper
, remove the paper, and go to the next step.
2.
Change
Roll Holder Lock
switch on roll unit to release position.
2.
3.
Hold flanges (A) so that holder stopper is on left, align roll holder shaft with roll holder slot
3.
left and right guide grooves (B), and load.
98