Canon imagePROGRAF TX-4100 MFP Z36 imagePROGRAF TX-4100 / TX-3100 / TX-2100 Qu - Page 12

9 Selecting the Method of Connecting to Your Computer When something like the following is displayed on the touch screen, select the connection method. Connect the printer to the network using a LAN cable. Connect the printer to the network wirelessly without using a LAN cable. Connect the printer to a computer using a USB cable. Select this such as when connecting using a fixed IP address. The connection settings and software installation will need to be performed separately. Start the settings from the touch screen of the printer. Wired LAN connection Wi-Fi connection USB connection 1 Select Wired LAN connection. Check the message about the 1 Select Wi-Fi connection. Check the message about the connection connection method and select Yes if method and select Yes if there are there are no problems. no problems. 1 Select USB connection. Check the message about the connection method and select Yes if there are no problems. ● A message prompting you to connect the LAN cable appears. ● A message prompting you to set up WiFi connection appears. ● Do not connect the USB cable yet. 2 Use the LAN cable to connect the wired LAN connector on the rear of the printer to the hub port. 2 Select Yes and proceed to "Installing the Software on Your Computer" (p. 11). ● To configure the settings from the printer, select No and proceed to "Configuring Wi-Fi Settings on the Printer Touch Screen" (column below). 2 Select OK and proceed to "Installing the Software on Your Computer" (p. 11). 3 Select OK and proceed to "Installing the Software on Your Computer" (p. 11). The printer starts charging the ink for the first time* and adjusting the print head. This takes around 25 minutes. Do not open the covers of the printer or turn the power off during this time. * Charges ink between the ink tank and print head and performs cleaning to keep the printer in optimal condition. This may cause the remaining ink indicator and maintenance cartridge capacity indicator to drop some amount. Since the included starter ink tanks are for initial installation, it is recommended that you purchase replacement ink tanks quickly. Configuring Wi-Fi Settings on the Printer Touch Screen For Wi-Fi connection 1 Check that the following screen appears and select Yes. 2 Check that the following screen appears and select Yes. 3 Configure the settings by following the instructions on the screen. ● When the home screen appears and (network) appears, the Wi-Fi settings are complete. Note ● If any of Checking the nozzle, Preparing the ink system, or Cleaning... is displayed, the printer initial settings are not finished. Wait until the above screen appears. 4 Proceed to "Installing the Software on Your Computer" (p. 11). 10