Canon imagePROGRAF W7200 Setup Guide - Page 25
Caution, Important, Setting Up the W7250 Without the Stand
View all Canon imagePROGRAF W7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
TSetting Up the W7250 Without the Stand The printer is placed directly at the location where it is to be used. Caution z The W7250 weights 60 kg (132 lb.) Make sure that the work table where the printer is to be located is level and strong enough to support the printer. Placing the printer on an uneven or unstable surface could cause it to fall and damage the printer or cause personal injury. z To prevent tipping the printer and damaging the printer or causing personal injury, never press down or lean on the roll media tray when it is open. 1 Lift the printer by the handles on both sides, then position the front edge of the printer (a) with the front edge of the work table so they are aligned. a Important z If the surface below the printer is gritty or dusty, this could damage the print surface of some roll media. In this case, spread sheets of plain paper (not film) under the printer as shown in the illustration below. 800mm (32in.) 500mm (20in.) 2 Select a Location for the Printer 1-13