Canon imagePROGRAF W8200 Network Guide - Page 16
Procedures Required for a TCP/IP Network, Important
View all Canon imagePROGRAF W8200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Procedures Required for a TCP/IP Network Here is a summary of the procedures required to set the printer for use on a TCP/IP network. 1 Connect the network cable. ÆSetup Guide Follow the instructions in the Setup Guide to connect the network cable. 2 Setting the Printer IP Address ÆP.2-3 Setting the IP address allows setting the printer protocol to enable communication between the printer and the computer . You can use one of the methods below to set the protocol: • GARO Device Setup Utility (Canon software application provided with the printer) • ARP/PING command • Printer operation panel 3 Setting TCP/IP Protocol for the Printer ÆP.2-8 Perform this procedure to set the printer protocol. You can perform these settings with the web browser from a computer on the network: • Web browser (Remote UI) 4 Setting the Computer ÆP.2-13 This procedure is performed for each computer to be used for printing. Important z Steps 1, 2, and 3 should be performed by the network system administrator. z An LPD connected print application can be used to print on the TCP/IP network. z This printer is not compatible with RAW protocol. If you are using Windows XP or Windows 2000, you must set and use LPR protocol. 2-2 TCP/IP Network Settings (Windows)