Canon imagePROGRAF iPF850 Setup Guide - Page 3

Assemble the Stand Assemble the stand on which you will install the printer. -> Refer to "Assemble the Stand" in the Printer Stand Setup Guide Install the Roll Unit Attach the roll unit to the stand. -> Refer to "Install the Roll Unit" in the Printer Stand Setup Guide Install the Printer 1 Remove the packaging material on top of the printer. 2 While two people hold the carrying handles under the printer on one end and lift the printer a little, have a third person remove the packaging material and the plastic covering from under the printer. After the packaging material has been removed, lower the printer. 3 Remove the packaging material and the plastic covering from the other side of the printer the same way. 4 Pull out the roll unit. 5 With three people holding the carrying handles under the printer on both ends, lift the printer. • The printer alone weighs approximately 2 • When moving the printer, firmly grasp the kg. Moving the printer requires at least six Caution people, three on either side. Be careful to carrying handles (a) under each side. Holding the printer at other positions is dangerous avoid back strain and other injuries. and cause injury and damage if the printer is dropped. • When setting the printer down temporarily make sure to put the printer on a flat, stable place. • When standing the printer up, make sure the side with the control panel is up, and place cardboard or other material underneath to prevent scratching. Furthermore, make sure that the weight of the printer is taken by the corner of the printer. If the weight is taken by any other part of the printer, the printer may become damaged. a • When standing up the printer or supporting the printer, hold the metal parts of the printer. If you hold a plastic part, the printer may become damaged. • The way to set the printer down or to carry with the load only to the center of the printer, may cause damage to the printer. 3