Canon imagePROGRAF iPF850 Setup Guide - Page 7

Install the Ink Tanks Install the 5 ink tanks. 1 Press the Power button to turn on the printer. 2 When the following screen appears, use the ▲ and ▼ keys to select a language and press OK. Language 1/2 English 日本語 Français Italiano Deutsch 3 Select your local time zone and press OK. Time Zone 1/5 0:London (GMT) +1:Paris,Rome +2:Athens,Cairo +3:Moscow +4:Eerevan,Baku 4 Instructions on ink tank installation are shown on the display screen. Open the ink tank covers as instructed. 5 Raise the stopper (a) of the ink tank lock lever for the color you are mounting. After raising the ink tank lock lever as far as possible, pull it forward. 6 Shake each ink tank gently 7 to 8 times before opening its pouch. M BK R G M BK a M BK G • Press down on the ink tank lock lever until it locks. • Make sure the ink tank lock lever stays in the locked position. • Failure to shake the ink tanks may result in reduced print quality because ink ingredients have settled on the bottom of the tank. • If the ink tank is cold, allow it to adjust MEMO to room temperature before attaching it to the printer. 7 Open the pouch and remove the ink tank. a b 8 Orient the ink tanks and mount them in the holders with ink holes down as shown in the figure. 9 After raising the ink tank lock lever as far as possible, press it back down until it clicks into place. At this time, repeat steps 5 and 9 two to three times to ensure that the ink tank is securely installed in the printer. BK • Never touch the ink holes (a) or metal contacts (b). Touching ab GY these parts may cause stains, damage the ink tank, and affect print quality. • An ink tank cannot be mounted in the • Avoid dropping the ink tank after removing it from the pouch. Otherwise, ink may leak and cause stains. • Do not remove ink tanks to shake them after they have been mounted. Doing so may cause ink to spill. holder if it is not oriented correctly for the color. • Do not try to force an ink tank into the holder if it does not go in normally. Check the color indicated on the label affixed to the ink tank lock lever and the ink tank orientation, and then try mounting the tank into the holder again.