Canon imagePROGRAF iPF9400 Setup Guide - Page 10
Load Paper to Adjust the Printheads
View all Canon imagePROGRAF iPF9400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 Repeat steps 3 to 9 to install the second printhead set. 11 Pull the carriage cover forward. 12 Close the top cover. Load Paper to Adjust the Printheads Load the provided sample paper and adjust the Printheads. 1 Select type of paper for printhead adj. is shown on the display screen. Use the ▲ and ▼ keys to select Roll Paper and then press OK. 2 Open the top cover and raise the ejection guide. 3 Remove the roll holder from the printer. 4 Raise the holder stopper lever (a) from the shaft side to unlock the stopper. While holding the holder stopper in the position in the figure indicated by (b), remove the holder stopper from the roll holder. 5 With the leading edge of the roll of paper towards the front as shown in the figure, insert the roll holder from the right side of the roll of paper. Insert the roll holder all the way until the paper is touching the flange (a) of the roll holder. a a b • We recommend wearing clean cotton gloves when handling rolls of paper to protect the printable surface. • Insert the roll holder as far as it will go so there is no gap between the paper and the roll holder flange. A gap can cause the paper to feed irregularly. • Do not place a roll of paper on a desk or other flat surface where it may roll off. A falling paper roll creates the risk of personal injury. • Do not allow the roll holder to be subjected to strong impact when loading a roll of paper. Strong impact can damage the roll holder. 6 As shown in the figure, slide the holder stopper onto the roll holder from the left. Holding the holder stopper at the position in the figure marked (b), press until the holder stopper flange (a) is securely in contact with the paper. Lower the holder stopper lever (c) to the shaft side to lock it. b 7 With the side of the roll holder with the white gear facing the same direction as the roll holder slot with the white gear, set the roll holder shaft (a) into the left and right guide grooves (b) of the roll holder slots. Allow the shaft to slide into the guides as far as possible. b a a c a b • Insert the roll holder as far as it will go so there is no gap between the paper and the roll holder flange. A gap can cause the paper to feed irregularly. • Remove all wrinkles and curls from the paper, if any, before loading it. 10 • When setting the shaft into the guides, take care so the roll of paper does not fall and created the risk of personal injury. • Be careful to not pinch your fingers between the shaft of the roll holder shaft (a) and the guide grooves (b) when loading a roll of paper.